Remove your SmartRG SR515 from the box. You should have:
- Power Adapter
- Ethernet Cable
- DSL Cable
Connecting the Cables:
1. Plug the power adapter into the back of the SmartRG and also into an electrical outlet. Ensure the on/off button on the side of the SmartRG is pushed in. You should see a Power light.
2. If you are on FIBER – Plug the white Ethernet cable into the port on the SmartRG router labelled WAN. The other end of this cable should go to an Ethernet jack in the wall or directly to ETH 1 on the Fibre Optic modem. The WAN light should go solid within a few minutes.
2.1 If you are on DSL – Plug the DSL (phone) cable into the port on the SmartRG labelled DSL. The other end of this cable should go to a phone jack in the wall. The DSL light should go solid within a few minutes.
3. Wired devices can be connected using an additional Ethernet cable (not included) plugged in to any one of the yellow LAN ports on the SmartRG unless the SmartRG is also being used for TV services.
If TV service is also configured on this router, use LAN Port 1 only for devices.
* The SmartRG On/Off – Power Button
Located on the side of the SmartRG. The power light is on the top of the modem.